Delta DVP-ES2 — 3.8 Detailed Instruction Explanation

3. Instruction Set API 191 Operands: S 1 : Number of output pulses on X axis S 2 : Number of output pulses on Y axis S : Max. point to point output frequency D : Pulse output device Explanations: 1. For ES2/EX2 models, only V1.20 or above supports the function. 3. S 1 and S 2 specify the number of output pulses (relative positioning) on X axis (Y0) and Y axis 2. The instruction only supports the pulse output type: Pulse / Direction. (Y2). Range: -2,147,483,648 ~ +2,147,483,647 (The “+/-“ sign indicates the forward/backward direction). In forward direction, the present value of pulse output on CH0 (D1031 High, D1030 low), CH1 (D1337 high, D1336 low) increases.

In reverse direction pulse output, value in (D1031, D1330) and (D1336, D1337) decreases. 4. S : If the max output frequency is smaller than 100Hz, the output will be operated at 100Hz. If the setting is bigger than 100kHz, the output will be operated at 100kHz 5. D can designate Y0 only. Y0 is the pulse output point of X axis; Y1 is the direction signal output of X axis.(OFF: positive; ON: negative) Y2 is the pulse output point of Y axis; Y3 is the direction signal output of Y axis (OFF: positive; ON: negative) When the pulse output is completed, the direction output signal will not be OFF unless the drive contact is OFF. 6. D1340 is start/end frequency setting of X/Y axis.

When the set value is smaller than 6Hz, PLC will take 6 Hz as the set value. D1343 is the ramp up/down time setting of X/Y axis. If the ramp up/down time is shorter than 20ms, the frequency will be operated at 20ms. Default: 100ms. 7. When PPMR instruction is enabled, the start frequency and acceleration/deceleration time in Y axis will be the same as the settings in X axis. In addition, setting ramp-down time individually by D1534 is not recommended because it could lead to the inconsistency between X and Y axes. Also, the flags of “pulse output pause (immediate)” are not applicable. To stop the pulse output, simply turn off the drive contact of this instruction. 8.

For pulse output with ramp-up/down section, if only 1 axis is specified with pulse output number, 3-457 Mnemonic Operands Function Controllers D PPMR 2-Axis Relative Point to Point Motion ES2/EX2 SS2 SA2 SX2 SE Type OP Bit Devices Word devices Program Steps X Y M S K H KnX KnY KnM KnS T C D E F DPPMR: 17 steps S 1 * * * S 2 * * * S * * * D * PULSE 16-bit 32-bit ES2/EX2 SA2 SA2 SA2 SS2 SX2 ES2/EX2 SS2 SX2 ES2/EX2 SS2 SX2 SE SE SE