DVP-ES2/EX2/SS2/SA2/SX2/SE&TP Operation Manual - Programming 3. Description of the number of output pulses in the idle time: requency 1/20 of the . Number of pulses in the Idle time The number of pulses in the last section of the ramp down time is not included Number of pulses in the Idle time The number of pulses in the last section of the ramp down time is included. ES2/EX2 V3.28 (and below), SA2/SX2 V2.82 (and below), and SS2/SE: Time(Sec) The nunmber of ouput pulses in the idle time in D1244/D4245 includes the numbers of pulses in the last section of the ramp down time.
If the target number of feedbacks is 50000, the number of output pulses in the idle time is 1000, the number of pulses in the laste section of the ramp down time is 50, and no external interrupt occurs, the total number of pulses will be 50665 (50000+100-50). ES2/EX2 V3.40 (and above), and SA2/SX2 V2.84 (and above): The nunmber of ouput pulses in the idle time in D1244/D4245 does not include the numbers of pulses in the last section of the ramp down time.
If the target number of feedbacks is 50000, the number of output pulses in the idle time is 1000, the number of pulses in the laste section of the ramp down time is 50, and no external interrupt occurs, the total number of pulses will be 51000 (50000+100). 4. Principles for adjusting the completion time of positioning: a) The completion time of positioning refers to the total time of “ramp up + high speed + ramp down + idle” (see the figure above). When percentage value (D1131/D1132) is modified, the total number of output pulses will be increased or decreased as well as the completion time.
b) When S 1 designates input points X with interrupt pointers, D1244 / D1255 can be applied for setting the idle time as limited pulse number, in case the interrupt is not properly triggered.Users can determine if the execution result is good or bad by the length of the idling time. In theory, a bit of idling left is the best result for a positioning. c) Owing to the close loop operation, the length of idle time will not be the same in every execution.
Therefore, when the content in the special D for displaying the actial number of output pulses is smaller or larger than the calculated number of output pulses (target 3-474 Pulse speed(Hz) Time interval for the pulse Target speed output in each shift is 1/20 of the ramp up tim e/ramp 2020 down time. 19 19 The change o ... ... in every shif is 7 Target number 7 most high spe of feedbacks 6 6 5 5 20-shifts 20-shifts 4 4 Idle 3 3 2 2 1 1 Ti Ramp up time Ramp down time 3000ms 3000ms 1 Ti Ramp up time Ramp down time 3000ms 3000ms