3. Instruction Set 3. Observe the results of the first execution: a) The actual output number 50,600 – specified output number 50,000 = 600 b) 600 x (1/100Hz) = 6s (idle time) c) 3 seconds are too long. Therefore, increase the percentage value (D1131) to K101. 4. Obatin the results of the second execution: Frequency 100KHz C243 =K50000 Y0 output stops D1340 Time Pulse number D1348 D1343 600ms Specified number of output pulses: 50,500 Actual number of output pulses (D1030, D1031) = K50,560 5. Observe the results of the second execution: a) The actual output number 50,560 – specified output number 50,500 = 60 b) 60 x (1/100Hz) = 600ms (idle time) c) 600ms is an appropriate value.
Therefore, set the percentage value (D1131) as K101 to complete the design. Points to note: 1. Associated flags: 3-477 M1029: CH0 (Y0, Y1) pulse output execution completed. M1102: CH1 (Y2, Y3) pulse output execution completed. M1078: M1078 = ON, CH0 (Y0, Y1) pulse output pause (immediate) M1104: M1104 = ON CH1 (Y2, Y3) pulse output pause (immediate) M1108: CH0 (Y0, Y1) pulse output pause (ramp down). M1108 = ON during ramp down. M1110: CH1 (Y2, Y3) pulse output pause (ramp down). M1110 = ON during ramp down. M1156: Enabling the mask and alignment mark function on I400/I401(X4) corresponding to Y0. M1158: Enabling the mask and alignment mark function on I600/I601(X6) corresponding to Y2.
M1538: Indicating pause status of CH0 (Y0, Y1).M1538 = ON when output paused. M1540: Indicating pause status of CH1 (Y2, Y3). M1540 = ON when output paused M1305: Reverse CH0 (Y0, Y1) pulse output direction. M1305 = ON, pulse output direction is reversed.