Delta DVP-ES2 — 3.8 Detailed Instruction Explanation

DVP-ES2/EX2/SS2/SA2/SX2/SE&TP Operation Manual - Programming 338 Operands Node : Specified node ID Dest : Target device for storing data Len : Total number of 4 words of data which have been read Ok : Completion flag Err : Error flag Explanation 1. EMER instruction is supported for firmware V3.60 or later. And it can work with CANopen DS301 mode and Delta special mode. 2. After receiving the Emergency message from the slave Node , the PLC will automatically store the data in the device that is specified by Dest and set the Ok flag to ON. 3. It is recommended that the Node value should be specified from the slave node IDs which have already existed.

If the value is not one existing node ID or the slave has been disconnected, the PLC will not be able to receive any message, set the Err flag to ON and show error code of communication timeout. (Refer to explanation of D6001 for error codes.) 4. The way the EMER instruction reads Emergency messages is the same as Emergency communication method in ES2 operation manual. Select one communication method from them when reading Emergency messages. Two methods cannot be used at the same time. 5. The EMER instruction can read 5 Emergency messages at most. Every time the reading is successful, the Ok flag turns on and Len displays the total number of messages which are read.

You can evaluate how many consecutive words are occupied by Dest based on the length. Every message uses 4 words. The data are stored in the order from lower 8 bits to higher 8 bits. 3-576 Mnemonic Operands Function Controllers ES2-C EMER Node, Dest, Len, Ok, Err Reading Emergency message Type OP Bit Devices Word devices Program Steps X Y M S K H KnX KnY KnM KnS T C D E F EMER: 11 steps Node * * * Dest * Len * Ok * Err * PULSE 16-bit 32-bit ES2-C