DVP-ES2/EX2/SS2/SA2/SX2/SE&TP Operation Manual - Programming The format of the reply message: The definition of the reply code in the reply message: NMT (network management object) The CANopen network management conforms to the “master/slave” mode. Only one NMT master exists in the CANopen network, and other nodes are considered slaves. NMT realized three services. They are module control services, error control services, and boot-up services. Module control services The master node in the CANopen network controls the slave by sending the command. The slave executes the command after it received the command. It does not need to reply. All CANopen nodes have internal NMT states.
The slave node has four states. They are the initialization state, the pre-operational state, the operational state, and the stop state. The state of the device is illustrated below. (1) After the power is supplied, the device automatically enters the initialization state. (2) After the initialization is complete, the device automatically enters the Pre-operational state. (3)(6) The remote node is started. (4)(7) The device enters the Pre-operational state. (5)(8) The remote node is stopped. (9)(10)(11) The application layer is rest. (12)(13)(14) The communication is reset. (15) After the initializing is complete, the device automatically enters the “reset application” state.
(16) After the “reset application” state is complete, the device automatically enters the 7-12 COB-ID Byte 0 Byte 1 Byte 2 Byte 3 Byte 4 Byte 5 Byte 6 Byte 7 580(hex) +Node-ID Reply code Object index Object subindex Reply data LSB MSB bit7-0 bit15-8 bit23-16 bit31-24 Reply code (hex) Description 43 Reading the 4-byte data 4B Reading the 2-byte data 4F Reading the 1-byte data 60 Writing the 1/2/4-byte data 80 Stopping the SDO function (1) Initializing (15) Initialization Reset application (16) Reset communication (11) (2) (14) Pre-operational (7) (10) (3) (4) (5) (13) Stopped (6) (8) (12) (9) Operational Operational