DVP-ES2/EX2/SS2/SA2/SX2/SE&TP Operation Manual - Programming Function Group Clear Instruction Number M1031, M1032 Contents: M1031 (clear non-latched memory), M1032 (clear latched memory) Function Group Output State Latched in STOP mode Number M1033 Contents: When M1033 = ON, PLC outputs will be latched when PLC is switched from RUN to STOP. Function Group Disabling all Y outputs Number M1034 Contents: When M1034 = ON, all outputs will turn off. Function Group RUN/STOP Switch Number M1035 Contents: When M1035 = ON, PLC uses input point X7 as the switch of RUN/STOP. Function Group COM Port Function Number Contents: COM ports (COM1: RS-232, COM2: RS-485, COM3:
RS-485) support communication format of MODBUS ASCII/RTU modes. When RTU format is selected, the data length should be set as 8. COM2 and COM3 support transmission speed up to 921kbps. COM1, COM2 and COM3 can be used at the same time. COM1: Can be used in master or slave mode. Supports ASCII/RTU communication format, baudrate (115200bps max), and modification on data length (data bits, parity bits, stop bits). D1036: COM1 (RS-232) communication protocol of master/slave PLC. (b8 - b15 are not used) Please refer to table below for setting. COM2: Can be used in master or slave mode.
Supports ASCII/RTU communication format, baudrate (921kbps max), and modification on data length (data bits, parity bits, stop bits). D1120: COM2 (RS-485) communication protocol of master/slave PLC. Please refer to table below for setting. COM3:
2-50 Device Devices will be cleared M1031 Clear non-latched area Contact status of Y, general-purpose M and general-purpose S General-purpose contact and timing coil of T General-purpose contact, counting coil reset coil of C General-purpose present value register of D General-purpose present value register of T General-purpose present value register of C M1032 Clear latched area Contact status of M and S for latched Contact and timing coil of accumulative timer T Contact and timing coil of high-speed counter C for latched Present value register of D for latched Present value register of accumulative timer T Present value register of high-speed counter C for latched Port COM1 COM2 COM3 Item Communication format D1036 D1120 D1109 Communication setting holding M1138 M1120 M1136 ASCII/RTU mode M1139 M1143 M1320 Slave communication address D1121 D1255