Delta DVP-ES2 — C.4.1 Basic Instructions

Appendix C Inforamation about TP Series Text Panels C.4 Instructions applicable to TP The instructions which are applicable to TP are listed below. Please refer to chapter 3 for more information about the instructions. C.4.1 Basic Instructions C-21 OFF STOP RUN Special Latch- Function    Attrib.

Default M ed ON RUN STOP M1429* Indicate that writing to Slave ID#6 is completed OFF - - R NO OFF M1430* Indicate that writing to Slave ID#7 is completed OFF - - R NO OFF M1431* Indicate that writing to Slave ID#8 is completed OFF - - R NO OFF M1432* Indicate that writing to Slave ID#9 is completed OFF - - R NO OFF M1433* Indicate that writing to Slave ID#10 is completed OFF - - R NO OFF M1434* Indicate that writing to Slave ID#11 is completed OFF - - R NO OFF M1435* Indicate that writing to Slave ID#12 is completed OFF - - R NO OFF M1436* Indicate that writing to Slave ID#13 is completed OFF - - R NO OFF M1437* Indicate that writing to Slave ID#14 is completed OFF - - R NO OFF M1438* Indicate that writing to Slave ID#15 is completed OFF - - R NO OFF M1439* Indicate that writing to Slave ID#16 is completed OFF - - R NO OFF Instruction Function LD Load NO contact LDI Load NC contact AND Connect NO contact in series ANI Connect NC contact in series OR Connect NO contact in parallel ORI Connect NC contact in parallel ANB Connect a block in series ORB Connect a block in parallel MPS Start of branches.

Stores current result of program evaluation MRD Reads the stored current result from previous MPS MPP End of branches. Pops (reads and resets) the stored result in previous MPS OUT Output coil SET Latches the ON status RST Resets contacts, registers or coils MC Master control Start MCR Master control Reset END Program End NOP No operation P Pointer I Interrupt program pointer STL Step ladder start instruction RET Step ladder return instruction NP Negative contact to Positive contact