Delta DVP-ES2 — C.4.3 Additional Remarks on High-speed Instructions

DVP-ES2/EX2/SS2/SA2/SX2/SE&TP Operation Manual - Programming C.4.3 Additional Remarks on High-speed Instructions 1. TP only supports the high-speed inputs X0 and X1 (10KHz). (Please refer to section 2.12 for more information.) TP04P-08TP1R does not support high-speed inputs (only supports up to 500HZ). 2. TP only supports the software counters C235 and C236. The corresponding high-speed interrupts are I010 and I020. (Please refer to the explanations of API53 and API55 for more information.) 3. TP onlyt supports the hardware counter C251. The corresponding high-speed interrupt is I010. There is only one hardware comparator.

(Please refer to the explanations of API53 and API55 for more information.) C-26 Mnemonic Classification API PULSE Function 16 bits 32 bits Contact Type Comparison 245 OR DOR – S ≦ S 1 2 246 OR>= DOR>= – S ≧ S 1 2 Specific Bit Control 266 BOUT DBOUT – Output specified bit of a word 267 BSET DBSET – Set ON specified bit of a word 268 BRST DBRST – Reset specified bit of a word 269 BLD DBLD – Load NO contact by specified bit 270 BLDI DBLDI – Load NC contact by specified bit 271 BAND DBAND – Connect NO contact in series by specified bit 272 BANI DBANI – Connect NC contact in series by specified bit 273 BOR DBOR – Connect NO contact in parallel by specified bit 274 BORI DBORI – Connect NC contact in parallel by specified bit Floating-Point Contact Type Comparison 275 – FLD= – S = S 1 2 276 – FLD> – S > S 1 2 277 – FLD – S < S 1 2 278 – FLD – S ≠ S 1 2 279 – FLD – S ≦ S 1 2 280 – FLD>= – S ≧ S 1 2 281 – FAND= – S = S 1 2 282 – FAND> – S > S 1 2 283 – FAND – S < S 1 2 284 – FAND – S ≠ S 1 2 285 – FAND – S ≦ S 1 2 286 – FAND>= – S ≧ S 1 2 287 – FOR= – S = S 1 2 288 – FOR> – S > S 1 2 289 – FOR – S < S 1 2 290 – FOR – S ≠ S 1 2 291 – FOR – S ≦ S 1 2 292 – FOR>= – S ≧ S 1 2