Delta DVP-ES3 — 6.6.1 Creating a Connection

Chapter 6 Writing a Program (5) Set the parameters in the Driver Properties dialog box, and then click OK . Type a driver name in the Driver Name box. Select USB (Virtual COM ) in the Type list in the Connection Setup section. Select a communication port in the COM Port list. If the first two steps are complete, the connected PLC and its communication port display in the COM Port list. 6_ Select the number of times to retry the sending of a command if a connection error occurs in the Time of Auto-retry box, and select a retry interval in the Time Interval of Auto-retry box. (6) After you finish the setup, USB_Driver appears in the COMMGR window.

When the connection is normal, OK appears in the Status column. 6-25