Delta DVP-ES3 — 4.1.1 DVP-ES3 Hardware Component

Chapter 4 Installing Hardware 4.1 DVP-ES3 Hardware Framework 4.1.1 DVP-ES3 Hardware Component The DVP-ES3 series programmable logic controller is a small programmable logic control (PLC). The execution speed and memory capacity are increased. Use of function blocks is also supported. In order to meet your more advanced application requirements, the DVP-ES3 series programmable logic controllers provide more flexible system extension frameworks. Under such system frameworks, you do not need to use several CPU modules to control the system because there are too many I/O points or the equipment is too far away.

This retains system completeness, and you can be more efficient in developing projects. The minimum framework requirement for the DVP-ES3 series system is only one CPU module. DVP-ES3 CPU module (the example below uses AC power supply model) 4_ first two limits causes the PLC to send an error message. The following lists the limits for setting up a common framework of the DVP-ES3 PLC system. Exceeding the Limit 1: The maximum number of digital I/O points is 256. The built-in digital I/O points of the CPU module are included. If DI points are 200, you can have less than 56 DO points. Limit 2: You can connect up to 8 modules (AD, DA, XA, PT, TC or PU) to the PLC. Limit 3:

The maximum power consumption of CPU module and extension module should be within the range of what a CPU module or a power module can supply. Refer to section 4.5.4 for the maximum power consumption of modules. 4-3 L N E thernet S/SX 0X1X2X 3X4X5X 6X7X10X11 X 12 X13 X14 X 15 X16 X17 D+D SGD+D C0Y 0Y 1 Y2Y 3Y4Y5Y 6Y7 Y10 Y 11 Y 12 Y13 Y14 Y15 Y16 Y17