Delta DVP-ES3 — 4.6.4 Wiring CANopen Terminals

Chapter 4 Installing Hardware 4.6.3 Wiring RS-485 Terminals 1 2 2 3 3 4 4 Note: 1. It is suggested to use 120 Ω terminal resistors on the master and the last slave. 2. Use two-wire shielded cables in a diameter of 20 AWG to ensure a quality communication. 4.6.4 Wiring CANopen Terminals 4_ 1 2 3 3 4 Note: 1. It is recommended to use Daisy Chain for connection and be sure to use 120Ω terminal resistor in the beginning and the end of the terminal arrangement. 2. GND is the grounding signal for CANopen network. 4-21 D+ D- D+ D- D+ D ① Master ② Slave ③ Terminal resistor ④ Shielded cable CAN +CAN- GND CAN+ CA N-GND CAN+ CA N- ① Master ② Slave ③ Terminal resistor ④ Shielded cable