Chapter 6 Applied Instructions Example 1. Draw a rhombus as in the figure below. Axis Y (0,0) Axis X (-27,000, -27,000) (27,000, -27,000) (0, -55,000) 2. Steps: Set the four coordinates (-27000, -27000), (0, -55000), (27000, -27000) and (0, 0) as in the figure above. Place them in the 32-bit registers (D200, D202), (D204, D206), (D208, D210), (D212, D214). RUN the program in the PLC. Set M0 to ON to start the 2-axis line drawing. 6_ 6-825