Delta DVP-ES3 — 6.26.2 Explanation of High-speed Output Instructions

Chapter 6 Applied Instructions Explanation 1. This instruction draws a circle based on relative positioning. S 1 and S 2 are respectively the X and Y axis coordinates of the center of a circle (relative position). 2. S 3 is the setting value for function selection. See the descriptions below. 6_ 3. D 1 and D 2 are the pulse output devices for the X and Y axes respectively. Refer to DPPMR instruction (API 2710) for the selection of output points and output mode for the axes. 4. S 4 sets the target frequency for the reference. The target reference frequency is used for the prior calculation when the PLC plans the travel path for the arc after the instruction is executed.

But if the calculation process which is estimated cannot achieve the planned arc travel path, the output frequency is automatically decreased to fulfill the synchronized arc drawing function. 5. When the X axis coordinate of the center point O=0, point O is defined as the point staying in QI of point A if Y axis target coordinate >= 0. Whereas, if Y axis target coordinate A. 6. Refer to Example 2 from the DPPMR instruction (API 2710) for programming in ST language. 6-845 S3 : Function Selection Descriptions 0 The arc resolution uses a 10° arc as the basic angle for clockwise motion. 1 The arc resolution uses a 5° arc as the basic angle for clockwise motion.

2 The arc resolution uses a 10° arc as the basic angle for counterclockwise motion. 3 The arc resolution uses a 5° arc as the basic angle for counterclockwise motion. 4 The arc resolution uses a 1° arc as the basic angle for clockwise motion. 5 The arc resolution uses a 1° arc as the basic angle for counterclockwise motion. Other Seen as setting value in S5 is 0 The arc resolution uses a 1° arc as the basic angle for clockwise motion.