Delta DVP-ES3 — 6.26.2 Explanation of High-speed Output Instructions

DVP-ES3 Series Programming Manual 6. D 2 is the flag indicating the target speed and the adjusted ratio that you can change. When this flag is ON, the executing target speed can be modified. When the flag switches from ON to OFF, it is now decelerating and the current target speed will be processes as the target speed for the next output. 7. There is no limit on the number of times you can execute this instruction, but during execution, the designated high speed axis cannot be occupied by any other instruction, and the other instruction is not executed. The following graphic shows the output timing diagram.

Speed D 2 = OFF D 2 = ON S 3 x S 4 D 1 +1 = OFF S 1 S 2 Position D 1 +1 = ON S 3 x S 4 D 2 = ON D 2 = OFF Example When M0 is ON, the DPPGB instruction starts to move back and forth between the target positions that are calculated from the two relative target positions specified by S 1 and S 2, at the actual target speed of 8500 Hz (5000*1.7). Y0 is the output point. Y1=OFF means the positive direction. 6-862 6 _