DVP-ES3 Series Programming Manual 10. There is no limit to the number of times you can use this instruction. Several instructions can use one group of input points as its source of input count. But you need to clear the value in the input counter before execution of this instruction; especially when you are using one input and several outputs. And this instruction executes according to the axis number to record information about its input and output. The same axis can be used for several times but outputs the first starting one and then the second one. you must not output the same axis at the same time. If you use the same axis to output for several times, PLC 11.
The instruction cannot be used in the ST programming language, interrupt tasks or function block which is called only once. Note 1. The PLC calculates the input pulse frequency based on the input pulse width (ON) in the positive half cycle. If the proportion of the pulse width for ON:pulse width for OFF is not 1:1, the PLC takes the ON width as the standard for conversion by default. 2. The input pulse=ON means the input point LED is on. When using the MPG but it has not rotated yet, you can check if the input point LED is OFF and the flag for reversing the input direction is activated . 3. There is a 20 ms time difference in CANopen communication when executing this instruction.
If this worries you, use CSFO instruction instead, controlling the servo by the pulse output. _6 Example When M0 switches from OFF to ON, PLC starts to execute this instruction to initialize servo station address 1 and 2 until SM1681 is ON. When M1 switches from OFF to ON, PLC starts to execute this instruction to start servo station address 1 and when the servo is started, SM1651 is ON, meaning Servo-ON. When M2 switches from OFF to ON, PLC starts to execute this instruction to start servo station address 1 and when the servo is started, SM1652 is ON, meaning Servo-ON. When M3 switches from OFF to ON, input points X0 and X1 connect to the MPG to control 2 servos.
The proportions for the 1 st servo is 1 and for the 2 nd servo is 2. 6-918