Delta DVP-ES3 — 7.2.7 Other Errors (Without LED Indicators)

Chapter 7 Troubleshooting 7_ 7-11 7024 The device length of the communication data in COM2 exceeds the limit. 1. Check the communication setting in the master and the slave. 2. Check the communication cable. - H 7027 The device checksum for the communication serial port of COM2 is incorrect. 1. Check the communication setting in the master and the slave. 2. Check the communication cable. - H 7031 The device communication function code in the Ethernet is incorrect. 1. Check the communication setting in the master and the slave. 2. Check the communication cable. - H 7032 The device communication address used in the Ethernet is incorrect. 1.

Check the communication setting in the master and the slave. 2. Check the communication cable. - H 7033 The device used in the Ethernet exceeds the device range. 1. Check the communication setting in the master and the slave. 2. Check the communication cable. - H 7034 The device length of the communication data in the Ethernet exceeds the limit. 1. Check the communication setting in the master and the slave. 2. Check the communication cable. - H 7037 The device checksum for the communication serial port of the Ethernet is incorrect. 1. Check the communication setting in the master and the slave. 2. Check the communication cable.

- H 7041 The device communication function code in the USB is incorrect. 1. Check the communication setting in the master and the slave. 2. Check the communication cable. - H 7042 The device communication address used in the USB is incorrect. 1. Check the communication setting in the master and the slave. 2. Check the communication cable. - H 7043 The device used in the USB exceeds the device range. 1. Check the communication setting in the master and the slave. 2. Check the communication cable. - H 7044 The device length of the communication data in the USB exceeds the limit. 1. Check the communication setting in the master and the slave. 2. Check the communication cable.

- H 7047 The device checksum for the communication serial port of the USB is incorrect. 1. Check the communication setting in the master and the slave. 2. Check the communication cable. - H 7203 Invalid communication function code 1. Refer to the function codes defined by the communication protocols. 2. Check if the product firmware and the software used are the most updated versions. 3. Make a note of the operation procedures and screenshots of the error windows and hand this note to the company or the technicians from the agents. - H 8105 The contents of the program downloaded are incorrect. The program syntax is incorrect. 1. Download the program and parameters again. 2.

Check the communication cable. 3. Save all the projects and compress the projects into one compressed file and then hand this file to the company or the technicians from the agents. - H