DVP-ES3 Series Programming Manual auto-rest flag to OFF and refresh the current corresponding output position in SR. But the PLC does not set the stop flag SM463 to ON. _6 Example 1 1. When M0 is ON, the PLC reads 16 states of the inputs X0 – X7 and X10-17 immediately, and refreshes the input signals without any delay. 6-172 Value in n D device Action Descriptions n = multiples of eight Y0 or X0 Refresh I/O immediately See Example 1 and 2 n = 1 High-speed output point Refresh new pulse positon See Example 3 n = 0 High-speed output point Without output completion auto-reset flag Stop high-speed outputting, set the stop flag SM463 to ON and refresh the current corresponding output position.
See Example 3 n = 0 High-speed output point With output completion auto-reset flag Set the output completion auto-reset flag to OFF and refresh the current corresponding output position. See Example 3. n = 1 Any input pint Refresh data mapping area in DS301 TxPDO (Slave to Master) immediately n = 1 Any output point Refresh data mapping area in DS301 RxPDO (Master to Slave) immediately