Delta DVP-ES3 — 6.19.2 Explanation of Communication Instructions

DVP-ES3 Series Programming Manual maximum 8. If the length of the transmitted message is 0, the communication mode will automatically change into the slave mode to receive messages without sending out any data. The mode can be used to monitor the communication packet. 5. S 4 is the starting device where transmitted data are stored and only the following 8 bits of data are used. For example, 4 messages are transmitted with D10 as the starting device. See the data transmission sequence as below. 6. If S 1 is the master mode in which the master will wait to receive data after sending data or the slave mode, the received data will be directly stored in the device specified by D 1 .

D100 is specified by D 1 Here See the stored content format. 2.0A mode setting: 2.0B mode setting _6 Note: If the Msg. ID to be received need be specified at the stage of receiving data, set the value of D 1 / D 1 +1 beforehand based on the 2.0A/2.0B mode. If the Msg. ID is not specified, please clear the value of D 1 / D 1 +1 to 0 before receiving data. 7. If S 1 is the master broadcast mode, the received data will be stored in the device specified by D 1 . D100 is specified by D 1 here. See the storage format as below. Device number specified by D 1 ) Selecting 2.0A mode: (Here is the introduction of receiving data from 2 slaves. For other data, please increase the 6-598 S4 No.

D10 D11 D12 D13 Description Data1 Data2 Data3 Data4 D1 No. D100 D101 D102 ~ D109 (Lower 8 bits) Description Msg. ID Data Length Data1 ~ Data8 D1 No. D100 D101 D102 D103 ~ D110 (Lower 8 bits) Description Msg. ID(Lo-word) Msg. ID(Hi-word) Data Length Data1 ~ Data8 Response Data from the second Data from the first slave Data from the third slave sequence slave D100 D101 D102 D103 ~ D110 (Lower 8 bits) D111 D112~D120 D121~130 D1 No. Receiving Packet number Msg. ID Data Length Data1 ~ Data8 Msg. ID Length, Data ID, Length, Data Description