Delta DVP-ES3 — 6.22.2 Explanation of Ethernet Instructions

Chapter 6 Applied Instructions 3. The email is set as follows. 4. In general, the MSENDP pulse instruction is used. Example Suppose the value in D0 is 00010100. When M0 is ON, the email is sent to email numbers 3 and 5. After the communication with the SMTP sever is complete, M20 is ON. If no error occurs during the communication, M21 is OFF and M50 is ON. 6-703 Operand Description Setting Range S1 Remote email number The value in S1 must be between 1–15. Set Bit 0–bit 3 in ISPSoft to indicate the remote email addresses. You can set up to four email addresses in ISPSoft. Bit 0 corresponds to email 1, bit 1 corresponds to email 2, and so on.

If you want to send an email, you must set the corresponding bit in ISPSoft. S2 Email subject Size of email subject: up to 16 words S3 Email body Size of email body: up to 64 words D Completion of the instruction After the execution of the instruction is complete, the bit is ON. If the execution of the instruction is abnormal, the next bit is ON. 6 6 _