Delta Electronics DVS — 3.12 Monitoring Settings

Chapter 3 Featured Functions 3.12 Monitoring Settings You can monitor the status of the Delta switch in real time via the functions in this group. IMPORTANT : Make sure that you save the configuration in the Save Configuration page after you have applied the configuration changes. (Save Config  Save Configuration) If you don’t save the configuration, then the configuration will be cleared after the switch is rebooted. 3-97 Description Factory Default Denial Of Service TCP Flag Select one of the following radio buttons:  Disable: This is the default setting.  Enable: All of the following packets are dropped:

- Packets that have a TCP flag SYN set and a TCP source port with a number lower than 1024 - Packets that have TCP control flags set to 0 and the TCP sequence number set to 0 - Packets that have TCP flags FIN, URG, and PSH set and TCP sequence number set to 0 - Packets that have both the TCP flags SYN and FIN set Disable Denial Of Service L4 Port Select one of the following radio buttons:  Disable: This is the default setting.  Enable: Packets that have a TCP source port that is equal to the TCP destination port are dropped, and packets that have a UDP source port that is equal to the UDP destination port are dropped.

Disable Denial Of Service ICMP Select one of the following radio buttons:  Disable: This is the default setting.  Enable: ICMP packets that have the type set to ECHO REQ (ping) _ and a size greater than the configured ICMP packet size are dropped. Disable Denial Of Service Max ICMP Size Specify the maximum ICMP packet size. Enter a value in the range of 0 to 1023 bytes. The default setting is 512 bytes. 512