Delta Electronics DVS — 3.5.1 IGMP Snooping Configuration

Chapter 3 Featured Functions 3.5.1 IGMP Snooping Configuration In this page, you can Enable or Disable IGMP Snooping. And it displays which VLAN enabled the IGMP Snooping function. IGMP Snooping Configuration VLAN IDs Enabled for IGMP Snooping This field displays the VLANs that are enabled for IGMP snooping. For information about how to configure a VLAN for IGMP snooping, see the following section. 3-63 Description Factory Default Admin Mode Specify the status of IGMP snooping:  Disable: The IGMP snooping is disabled. The IGMP setting still can be configured, but the settings do not take effect after you have applied them.  Enable: The IGMP snooping is enabled.

The switch snoops all IGMP packets it receives to determine which segments should receive packets directed to the group address. Disable Unknown Multicast Filtering Specify the status of the unknown multicast filtering:  Disable: Unknown multicast traffic is not filtered and is forwarded.  Enable: Unknown multicast traffic is filtered and dropped. Disable Querier Version Specify the IGMP protocol version used in periodic IGMP queries.  IGMP v1: Support member query and report function.  IGMP v2: Support general query (the same as IGMPv1), group-specific query, maximum response time and leave group message function.

2 Querier Interval (secs) Querier interval is the amount of time in seconds between IGMP General Query messages sent by the router (if the router is the querier on this subnet). Enter a period between 60 and 600 seconds. 125