Delta Electronics DVS — 3.10.1 MAC ACL

DVS Series Managed Industrial Ethernet Switches User’s Manual The steps of configuring an ACL: 1. Create a MAC-based ACL name. 2. Create a rule and assign it to an ACL. 3. Assign an ACL to an interface. IMPORTANT : Make sure that you save the configuration in the Save Configuration page after you have applied the configuration changes. (Save Config  Save Configuration) If you don’t save the configuration, then the configuration will be cleared after the switch is rebooted. 3.10.1 MAC ACL A MAC ACL consists of a set of rules that are matched sequentially to compare the packet. With a MAC ACL, you can specify the MAC address of the source device, destination device, or both.

When a packet matchs the criteria with a rule, and the specified rule action (permit or deny) is applied, then any additional rules will not be checked whether the packet is match or not. MAC ACL MAC ACL Table 3-76 Setting Description Current Number of ACLs The field displays the sum of the configured ACLs. Maximum ACLs The field displays the maximum number of MAC ACLs that can be configured (100). Setting Description Name Specify a name for an ACL. The name can include alphabetic, numeric, dash, underscore, or space characters. It must start with an alphabetic character. Rules The number of rules that are configured for the MAC ACL.

Direction The direction of packet traffic that is affected by the MAC ACL. This is a fixed entry that always shows In Bound; only inbound traffic is subject to the MAC ACL.