Chapter 4 Display and operation 4.1 Appearance of the display and key operation area UP 38 Technical Manual for EA190 Series Servo Driver V100 Name of Part Graphics in the document Function description MODE Switching between different operating modes Exit from the current parameter/function operation Exit from the mode to the normal operation mode UP The value where the cursor is currently located increases When it is the second level of AF-02 auxiliary function, jog forward When it is the second level of and , directly display the first level of the next parameter When it is the mode and an alarm is currently present, shift down to view the alarm message In the mode, AF-07 selected parameter and the driver status is switched for monitoring DOWN The value where the cursor is currently located decreases When it is the second level of AF-02 auxiliary function, jog reversely In the mode and an alarm is currently present, shift upward to view the alarm message When it is the second level of and , directly display the first level of the previous parameter SHIFT When it is the first level of the , and mode, the cursor moves rightward ( ); When it is the second level of the and mode, the cursor moves leftward ( Enter Confirm the current operation Digital tube The box contains information displayed on the digital tube; on the upper side of the box indicates flushing of the whole digital tube at corresponding location; on the lower side of the box indicates flushing of the lower right point of the digital tube at corresponding location; When the lower right dot “.” on the single LED4 is solidly on, it means the current screen is the second page of the current message; the first and second pages can be switched for display by using the key; Symbol “-” on LED4 means the current data is negative (the digit number of data on the current page≤4); When the lower right dots “..” on LED4 and LED3 are solidly on, it means the current data is negative (the digit number of data on the current page = 5);