Technical Manual for EA350 Analog Pulse Type Servo Driver V101 Parameter functions: Set the speed upper limit setting for activation ON when P0-13=1 or 3. If the motor speed is higher than the set value of this parameter, the servo activation cannot be turned ON. To set the condition for setting servo activation ON again after activation OFF, it is required to first set the braking mode P0-08, then select whether zero-speed braking requires setting activation ON condition P0-12 (free braking must be followed), and finally set the specific condition for activation ON. 128 address Unit rpm Time of taking effect With immediate effect Setting range 0~10000 Data size 16bit Control mode P S T