Driver Assist Features lane change. After the lane change is completed, please confirm that the turning signal lever has been toggled back. • The system will not perform the lane change if it detects that the conditions to change lanes has not been met and the dynamic environment simulation will display the light band on the corresponding side turning red. Before or during a lane change, toggle the turning signal lever in the opposite direction of the lane change to cancel the lane change. When the following situations occur, the lane change will be interrupted, and you will be reminded through the digital instrument panel and sound alerts of the need to take control of your vehicle:
• The Auto Lane Change (ALC) detects an unsafe lane change environment, such as when the activation alarms for Blind Spot Detection (BSD) and Lane Change Assist (LCA) go off. • Steer Assist is exited for reasons such as taking over the steering wheel control, unclear lane markings, and passing through excessively curved bends. • Adaptive Cruise Control and Steer Assist are exited at the same time for reasons such as pressing the button and depressing the brake pedal. Caution Active Lane Change can only change one lane at a time. Caution Assisted lane changes may fail if the light and visibility are poor at night, or when lane lines are not clear.
Warning Active Lane Change may suddenly be canceled due to unexpected circumstances. Please always pay attention to traffic and road conditions, and be prepared to take over at any time. Warning You must always confirm if it is safe and appropriate before and when changing lanes. Please note that Active Lane Change cannot respond to pedestrians, obstacles, oncoming vehicles, etc. Never rely solely on Active Lane Change to 257