4.2.6 DEMO MODE SETTING 4.3 Exiting DEMO mode To exit the demo cycle, switch the appliance off (programme selector in off/cancel position). 5 DIAGNOSTICS SYSTEM 5.1 Access to diagnostics mode 5.2 Exiting diagnostics mode To exit the diagnostics cycle, switch the appliance off, then on, and then off again. SOI/DT 2007-11 dmm 24/69 599 70 39-88 SERIES 6 WM/WD - SERIES 7 Special WM SERIES 7 WM/WD 1. Switch off the appliance. 2. Press and hold down START/PAUSE button and the nearest option button simultaneously (as represented in figure). 3. Holding down both buttons, switch the appliance on by turning the programme selector by three positions clockwise. 4.
Hold the buttons down till “dEM” flashes for a short time. SERIES 6 WM/WD - SERIES 7 Special WM SERIES 7 WM/WD 1. Switch off the appliance. 2. Press and hold down START/PAUSE button and the nearest option button (as represented in figure). 3. Holding down both buttons, switch the appliance on by turning the programme selector by one position clockwise. 4. Continue to hold down the buttons till the LEDs and the symbols begin to flash (at least 2 seconds). In the first position, the operation of the buttons and the relative LEDs is checked; turning the selector knob clockwise the diagnostics cycle for the operation of the various components and the alarm reading is activated.