7 OPERATING TIME COUNTER Using a specific procedure, the operator can display the total operating time for the appliance, which is counted from the moment it is first switched on. This option is available only on models equipped with a display. The unit can count up to a maximum of 6550 hours of operating time.
ѓ Only the operating time of normal programmes (and not diagnostic programmes) is counted ѓ The actual operating time for the cycle is counted (which does not include pauses, delayed start time, time of a stop with water in the drum, and soaking phases) ѓ The precision of the counter is 30 seconds per programme ѓ Only whole hours of operation are counted (1 hr and 59 min = 1 hr) 7.1.1 Reading of operating time 7.1.2 Display of total operating time with LEDs This time is displayed two digits at a time. The first two digits indicate the thousands and hundreds. The second two digits indicate the tens and units.
For example, if the operating time is 6550 hours, the display will show the following sequence: At the end of the phase 3 (after displaying the tens and units) the cycle repeats. To return to normal mode it is possible to: switch the appliance off or press a button or turn the selector knob. SOI/DT 2007-11 dmm 30/69 599 70 39-88 SERIES 6 WM/WD - SERIES 7 Special WM SERIES 7 WM/WD 1. Switch off the appliance. 2. Press the START/PAUSE button and the nearest option button (see figure) simultaneously. 3. Holding the buttons down, switch on the appliance turning the programme selector of five positions clockwise. 4.
Hold the buttons down till the LCD or the display show the working hours (at least 5 seconds). Phase 1 → Phase 2 → Phase 3 → Styling Nothing is displayed for two seconds The following digits are displayed for two seconds: ª thousands (6) ª hundreds (5) The following digits are displayed for the next two seconds: a. tens (5) b. units (0) SERIES 6 & 7 Special SERIES 7