Ц Washing cycle tables: Each washing cycle consists of a series of phases (steps); the steps are the basic instructions which comprise the description of the cycle, which is common to all appliances having the same characteristics: - Water fill - Motor movement - Reset - Heating - Drain - Spin - “IF” conditions (options, temperatures etc.) Ц Configuration of the washing cycle: for each family of appliances, certain parameters associated with the washing programme are defined:
- Operational limits (voltage/frequency) - Transmission ratios - Parameters for control of the signal from the tachometric generator - Parameters for half-range operation of the motor - Structure of the washing group - Control parameters for the FUCS anti-unbalancing system - Water fill control algorithm - Alarm control system - Sensor parameters (flowmeter etc…) 10.1.3 RAM The RAM (Random-Access Memory) contains the variables, i.e. all the dynamic information used during execution of the programme: Ц Motor speed Ц Water temperature Ц Alarms Ц Cycle selected Ц Machine status The RAM is cancelled when the power supply is disconnected (power failure or appliance switched off).
The contents of the RAM can be read using a computer connected via a DAAS interface. The same system can be used to send commands to the electronic control unit such as: Ц Select remote control mode Ц Action the various loads in remote mode Ц Select diagnostics mode Ц Select a cycle and options, and start the cycle SOI/DT 2007-11 dmm 39/69 599 70 39-88