9.5 Rear cabinet shell a. Remove the top b. Remove the screws which secure the cabinet shell to the upper cross-member (34) c. Remove the screw head masking caps and remove the lateral screws which secure the cabinet shell to the base (35) d. Detach the wire clamp from the cabinet (36) e. Remove the rear screws and slide the cabinet shell away from the base (37) N.B. : After removing the rear cabinet shell, special care must be taken when moving the appliance. When the shell is removed, never lay the appliance on its sides or on its back, since this might damage the internal structure. 9.5.1 Motor a. Remove the rear cabinet shell. b. Detach the wiring connectors. c.
Remove the rear screws which secure the motor and loosen the front screws (38) d. Loosen the motor from the supports (39) e. Remove the front screws and remove the motor. 9.5.2 Electronic speed control system / AC/DC converter a. Detach the cable connectors b. Press the two lateral anchor tabs and raise the cover of the casing (40). c. Remove the electronic board. SOI/DT 2002-05 eb 102 599 35 23-17