9.5.5 Detergent dispenser a. Remove the rear cabinet shell. b. Unscrew the clamp and detach the tube from the detergent dispenser to the tub c. Detach the steam venting tube from the tub (if present) d. Extract the detergent drawer (8) e. Remove the screw which secures the control panel to the detergent dispenser (9) f. Remove the screws which secure the detergent dispenser to the cross-member g. Remove the solenoid valve(s) (if fitted to the dispenser) or detach the tube(s) from the dispenser to the solenoid valve h. Detach the lever mechanism (46), if present i.
Release the two lateral anchor tabs from the front cross- member (47a) and, at the same time, push the detergent dispenser towards the rear j. Press down the lower anchor tab which secures the dispenser to the front cross-member (47-b) k. Lower the washing group and pull the dispenser out 8 9 9.5.6 Removing the duct from the dispenser a. Remove the dispenser b. Remove the lever regulation pin (if present) by pressing the two anchor tabs (48) c. Release the clamp and the anchor tabs for the duct from the lower part of the dispenser (49) From inside the dispenser, the engineer can access: a. The water intake nozzle, which is removed by lifting from the dispenser b. The steam venting tube c.
The water distributor 48 49 9.5.7 Water distributor This operation may be performed without removing the dispenser: a. Remove the detergent drawer (8) b. Release the spring (50a) c. Release the anchor tab and slide out (50b) d. Rotate and extract the distributor from inside the dispenser Note : When re-assembling, the specific grease MUST be applied to the distributor (50c) SOI/DT 2002-05 eb 104 599 35 23-17 a c 50 b