9.10.9 Drain filter body (standard version) a. Remove the rear cabinet shell b. Lay the appliance face-down c. Remove the circulation pump (if present) d. Detach the hoses from the filter body e. Remove the screws which secure the front shell to the base (75) f. Raise the base in order to detach the filter body from the front shell g. Release the tabs which anchor the filter body to the base (66) h. Remove the drain pump i. Remove the filter body 9.10.10 Heat exchanger (certain Jetsystem models only) a. Remove the rear cabinet shell b. Detach the circulation pump without detaching the hoses c. Disconnect the heat exchanger from the filter body Re-assembly:
Ensure that the two seals (O-rings) are correctly positioned on the heat exchanger. Lubricate with vaseline to facilitate insertion. 9.10.11 Base a. Remove the rear cabinet shell b. Remove the pins which secure the dampers to the base c. Cut the fixing ties and detach the wiring d. Release the speed control unit casing (if present) e. Detach the drying condenser (washer-dryers) f. Lay the appliance face-down g. Detach the drain hose h. Remove the lateral screws which secure the front shell to the base (75) i. Raise the base and remove the filter body j. Remove the base After re-assembly, connect the wiring correctly to the base and secure using new wiring ties.
SOI/DT 2002-05 eb 112 599 35 23-17