A special cycle is designed to demonstrate the operation of these appliances in shops, without connecting them to the water mains. Є The door lock is enabled regularly (door locked during operation, possibility of opening it at the end of the cycle or when paused) Є All low speed movements of the motor, the pulses and spin are disabled. Є the water fill solenoid valves and the drain pump are disabled Є The display shows only the setup process (START / PAUSE button is disabled), because without the movement of the door can not be seen and is therefore useless.
3 DEMO MODE 3.1 DEMO MODE SETTING Do not start the procedure with the combination buttons pressed Series 7 Series 8 3.2 Existing DEMO mode To quit the demo mode, unplug the appliance at the socket, because the ON/OFF button does not function. A.D.L. 10 / 2010 6/26 599 73 54-08 Turn the appliance on at the ON/OFF switch Turn the selector dial until the third LED in the right-hand row is on. Press the START/PAUSE button and the nearest option button simultaneously (as shown in the figure). Hold the buttons down (approximately three or five seconds) until “dEM” flashes for a short time.