User Manual EM303B General Purpose Inverter Speed Program Operation Mode Selection F6-00 ones place=0 Monocycle. Inverter will stop after running as per the time and operation of 7 preset speeds. F6-00 ones place=1 Run as per Preset Speed 7 after monocycle Inverter will run as per the preset speed 7 after running as per the time and operation of 7 preset speeds. F6-00 ones place=2Limited times of continuous cycle Inverter will run as per the preset speed 1 after running as per the time and operation of 7 preset speeds, and will stop after the cycling operation reached setting times. F6-15 sets the speed cycling times.
F6-00 ones place=3 Continuous cycle After running as per the time and operation of 7 preset speeds, inverter will run as per the preset speed 1. Unless the inverter gets the stop command, it will run from preset speed 1 to preset speed 7 circularly. Remarks: The preset speeds stated here are corresponding to the preset frequencies in F3 Group. Options of restart after operation paused F6-00 thousands place=0 Options of restart after operation paused In the process of program operation, if the external pause input is enabled, power fails or fault occurs, inverter will re-enter operation status and run as per the preset speed at pause.
F6-00 thousands place=1 Restart from Preset Speed 1 In the process of program operation, if the external pause input is enabled, power fails or fault occurs, inverter will re-enter operation status and run as per the preset speed 1. Program operation time unit F6-00 ten thousands place=0 Program operation time unit: Second F6-00 ten thousands place =1 Program operation time unit: Minute 8.8.2 Set the Acc./Dec. Time/Mode/Saving Options at Power-Failure for Each Section 123 No. Function Range Unit Default Type Preset Program Operation Section 1 Ones place: Motor running direction options 0: Forward 1: Reverse Tens place: Options of acceleration /deceleration time 0:
Acceleration / Deceleration time 1 1: Acceleration / Deceleration time 2 2: Acceleration / Deceleration time 3 3: Acceleration / Deceleration time 4 100 〇 F6-01 Preset Program Operation Section 2 100 〇 F6-02 Preset Program Operation Section 3 100 〇 F6-03 Preset Program Operation Section 4 100 〇 F6-04 Preset Program Operation Section 5 100 〇 F6-05