User Manual EM303B General Purpose Inverter Motor 2 Parameter Setting 8.12.3 Basic Parameters of Motor 2 When inverter is connected to Motor 2 at the first time, please set all parameters corresponding to the nameplate of Motor 2. 8.12.4 Motor 2 Running Parameters FA-21 ～ FA-27 are motor parameters. Users cannot know these parameters on general conditions, please obtain the parameters by motor parameter autotuning. Before motor parameter autotuning, inverter will set the motor nameplate parameters, which are set by FA-14~FA-20, as the standard motor parameters automatically. 8.13 FC Group:
Parameters of Operation Control 8.13.1 Acceleration/Deceleration Mode Control FC-00=0 Linear mode acceleration/deceleration Output frequency increases/decreases progressively in linear mode.Acceleration/Deceleration time is set by F0-09 and F0-10. FC-00=1 S curve mode acceleration/deceleration Output frequency increases/decreases progressively as per curve. Generally S curve is used for the applications which require smooth start and stop like elevator and conveyor. As shown in Figure 7-23, in the process of acceleration, t1 = the setting value of FC-01* Acceleration time, t2= the setting value of FC-02* Acceleration time. In the process of 146 No.
Function Range Unit Default Type FA-14 Motor 2 Rated Power 0.40～480.00 kW XXXX 〇 FA-15 Motor 2 Rated Voltage 60～660 V XXX 〇 FA-16 Motor 2 Rated Current 0.1～1500.0 A XXXX 〇 FA-17 Motor 2 Rated Frequency 20.00～600.00/20.0～6000.0 Hz XXXX 〇 FA-18 Motor 2 Rated Speed 1～60000 rpm XXXX 〇 FA-19 Motor 2 Wiring Mode 0：Y, 1：Δ X 〇 FA-20 Motor 2 Rated Power Factor 0.50～0.99 X 〇 No.
Function Range Unit Default Type FA-21 Motor 2 Idling Excitation Current I0 0.1～1500.0 A XXXX 〇 FA-22 Motor 2 Rated Torque Current 0.1～1500.0 A XXXX × FA-23 Motor 2 Stator Resistance R1 0.01～60.000 Ω XXXX 〇 FA-24 Motor 2 Rotator Resistance R2 0.01～60.000 Ω XXXX 〇 FA-25 Motor 2 Stator& Rotor Leakage Inductance Ls 0.1～3000.0 mH XXXX 〇 FA-26 Motor 2 Stator& Rotor Mutual Inductance Lm 0.1～3000.0 mH XXXX 〇 FA-27 Motor 2 Efficiency 30.0～99.0 % XXXX 〇 No. Function Range Unit Default Type Acceleration/Deceleration Mode 0：Linear mode 1：S curve mode 0 〇 FC-00 FC-01 Proportion of Acceleration S Curve 0.0～50.0 % 30.0 〇 FC-02 Proportion of Deceleration S Curve 0.0～50.0 % 30.0 〇