sinee — EM303B User Manual

User Manual EM303B General Purpose Inverter 3.2.6 Wiring the Output Side of Main Circuit Connecting the Inverter to Motor  Connect inverter output terminals U, V, and W to motor input terminals U, V and W.  Confirm that the motor forwards with the Forward Command. Switch any 2 of the inverter output terminals U, V, or W to each other and reconnect if the motor reverses. Never Connecting Power Supply Cable to Output Terminals Never connect power supply cable to output terminals. If the output terminalsare connected to power supply, the inverter would be damaged.

Never Short-Circuiting or Grounding Output Terminals Never touch output terminals directly with bare hands, or connect the output cable to the housing of inverter. Otherwise, an electric shock and short-circuit may occur. Furthermore, do not short-circuit the output cable. Never Using a Phase-shifting Capacitor Never connect phase-shifting electrolytic capacitor or LC/RC filter to the output circuit. Otherwise, inverter will be damaged. Never Using an Electromagnetic Switch  Never connect electromagnetic switch or electromagnetic contactor to the output circuit. Otherwise, failure to comply will cause overcurrent or overvoltage protection. Even worse, inverter will be damaged.

 Please make sure that the inverter stops before installing electromagnetic contactor to Installing a Noise Filter on the Output Side Install a noise filter on the output side of inverter to reduce inductive interference and radio interference.  Inductive interference: Electromagnetic induction generates noise on the signal line switch grid power supply. which may cause the control device malfunction.  Radio interference: The high frequency electromagnetic waves generated by inverter and cable cause radio devices nearby to make noise when receiving signals.

MCCB IM Inductive Interference Radio Frequency Interference Radio Device Signal Line Control Device Figure 3-8 Installing a Noise Filter on the Output Side 28 EM303B Inverter Noise Filter