User Manual EM303B General Purpose Inverter 6 Parameter Table 6.1 Format of Parameter Tables 17 groups of parameter of EM303B: F0, F1, F2, F3, F4, F5, F6, F7, F8, F9, FA, Fb, FC, Fd, FE, C0, and E0, 32 items in each group. F0~FE are function setting parameters which consist of two sections. Section 1: F0~F5, general parameters. Section 2: F6~FE are advanced parameters. Group C0 are status monitoring parameters. Group E0 are fault monitoring parameters. When F0-27=0, the inverter only displays the parameters of Group F0~F5, C0, and E0. When F0-27=1, the inverter displays all parameters. Column 1: the number of the parameter. Column 2: the function of parameter. Column 3:
the range of parameter. Column 4: the parameter unit. Column 5: the parameter default. For instance, XXX represents that the parameter default varies with the power ratings of inverter. Column 6: the type of parameter (whether the parameter is editable or not). Details shown as followings: “ ● ” : Parameter editing is permitted when the inverter is running. “ 〇 ” : Parameter editing is prohibited when the inverter is running. “X”: The parameter is read only. Unit and Its Abbreviation ★ The basic value of percentage is the rated value. 6.2 Parameter Table Section 1 General Parameters 6.2.1 F0 Group:
General Parameters 52 HOUR Hour m Meter % Percentage★ SQRT Square Root min Minute mm Millimeter rpm Revolutions per minute A Ampere S Second Hz Hertz MAX Maximum V Voltage mS Millisecond kHz Kilohertz MIN Minimum SECT Program Section mH Millihenry kW Kilowatt bps Bits per second No. Function Range Unit Default Type S/N F0-00 Speed Reference Input Monitoring Torque Reference Input Monitoring Frequency: 0.00～Fmax/0.0～ Fmax Speed: 0～F*Customer defined scaling Torque input: 0.00~Limited torque Hz rpm % 0.00/0 0.0/0 0.00 X 0 (L) 1 F0-01 (H)