EM500 Open-Loop Vector Control Inverter User Manual 112 Hundreds Place: DeviceNet 0: Initialization Status 1: MACID Detection Status 2: Online Non-Connection Status 3: Connection Status 4: IO Communication Overtime Status 5: DeviceNet Bus Communication Abnormality Status 6: Modbus Communication Abnormality Status 7:
Factory Test Status F10.48 Communication Card Software Version × F10.49 number of process data received 1～16 2 ● F10.50 number of process data transmission 1～16 2 ● F10.51 Process data address setting mode selection 0：keypad 1：Master 0 ● F10.52 Communication card manual reset selection 0：disable 1：enable 0 ● F10.53 CANSinee Communication address 1～31 1 〇 F10.54 CANSinee Communication baud rate 0：125K 1：250K 2：500K 3：1M 0 〇 F10.55 CANSinee Communication timeout 0.0 - 60.0, 0.0: Disabled (also works for master - slave system) s 0.0 ● F10.56 RS485write EEPROM 0～10：default for debugging 11:
No trigger write before debugging 0 〇 F11 User-Defined Parameter Group F11.00 User-Defined Parameter 1 The content displays Uxx.xx, which means that function code Fxx.xx is selected. If keypad displays U00.00 at U00.00 ● F11.01 User-Defined U00.01 ●