EM500 Open-Loop Vector Control Inverter User Manual 1.2 EM500 Operation Status 1.2.1Operating Status of Inverter EM500 inverter operating status: Parameter setting status, normal running status, JOG running status, autotuning status, stop status, JOG stop status and fault status. Parameter setting status: After it is powered on and initialized and is standby without a fault or a start-up command, inverter has no output. Normal running status: Having received an active start command through keypad, control terminal or communication, inverter drives motor as per the setting input. JOG running status: Drives motor at JOG input speed through setting of keypad, Autotuning status:
Set through keypad to autotune the parameters of motor in external terminal or communication. stationary or rotational autotuning. Stop status: When a running command is inactive, output frequency drops to zero JOG stop status: When JOG running command is inactive, output frequency as per set deceleration time. drops to zero as per JOG deceleration time. Fault status: Status of inverter under protection, and all kinds of faults and failures. 16 To be installed indoor with an altitude less than 1,000 meters, Installation Site free from dust, corrosive gas and direct sunlight.
Ambient -10℃ - +40℃, 20% - 90%RH (no condensation) Temperature Working Vibration Condition Storage -25℃ ~ +65℃ Temperature Installation Wall mounting, floor mounting (electrical cabinet) and flush Method mounting Protection Degree IP20/IP21 (450kW and above) Cooling Method Forced air cooling