EM500 Open-Loop Vector Control Inverter User Manual Appendix III Profibus-DP Expansion Card (EC-CM-P1) III.1 General Communication card EC-CM-P1 is defined as PROFIBUS-DP slave communication card and used to connect EM500 inverter to PROFIBUS-DP network. Main features: Support PZD control data exchange. Support PKW access to inverter parameters. Support the user diagnosis function. Automatic detection of communication rate, up to 12 Mbps. III.2 Installation Instructions Install Profibus-DP expansion card into the expansion slot EC-B (make sure that it is installed and buckled properly). Disassemble or install Profibus-DP expansion card only after inverter is powered off.
Figure 3 Installation of Profibus-DP expansion card 432