EM500 Open-Loop Vector Control Inverter User Manual 440 Flicker Already Connected Online, but Connection to Master Not Established master scan list Re-download configuration data to master Green Lamp On Communication Card Already Connected Online and Connection to Master Established No need to do anything Red Lamp Flicker Communication Card Already Connected Online and Single I/O Communication Overtime Configure communication card to master scan list; Re-download the configuration data to master Red Lamp On MACID Detection Failure; No Network Power Supply; Bus-off Confirm that there is no repeated node address on the network Check if the network power supply is normal Confirm whether the communication rate and the wiring are normal MS Off No Power Supply Check whether the power of communication card works normally Green Lamp Flicker Wait for I/O Data Switch PLC to RUN status Green Lamp On Normal I/O Data No need to do anything Red Lamp Flicker Mapping Error Configure communication card or power on inverter again Red Lamp On Hardware Error Return for repairing US Off No Power Supply Check if the power of communication card works normally Green Lamp Flicker Wait for Inverter to Return Data Confirm that communication card and inverter are connected together normally Green Lamp On Normal Data with Inverter No need to do anything Red Lamp Flicker Communication Overtime Confirm that communication card and inverter are connected together normally Red Lamp On Communication Failure Power it on again