EM500 Open-Loop Vector Control Inverter User Manual Figure 4-6 Changing Function Code under User-Defined Mode Rotate digital potentiometer in the second level menu under the user-defined mode to switch to the parameters set by previous or next user, because user can not add or remove any function parameter of the second level menu. Switch sequence: from the function parameter defined by F11.00 to the function parameter defined by F11.31. Press >> in the second level menu and cursor will not shift. After entering the third level menu by pressing ENTER , the lowest position of cursor will flash if current status of corresponding function code is permitted for change.
The method of changing parameters is the same as that in the third level menu under all menu modes; after changing, press ENTER to save the change and enter the next user-defined parameter. Changing the parameter in the third level menu under different menu modes has the same effect. 4.2.3Non-factory defaults (--C--) ENTER under this mode to enter the second level menu, which displays the first parameter that starts from F00.00 and differs from the default setting of inverter. No Press shifting works by pressing >> under this mode; no function group or function parameter may be changed arbitrarily by rotating digital potentiometer but one 66