sinee — 7.13 F12 Group: Keypad and Display Parameter

EM600 High-Performance Vector Control Inverter User Manual F11.00=U00.00, means that the first user-defined parameter is function code F00.00. The switching sequence of function codes under user-defined mode set by keypad shall be the sequence set by function codes F11.00 - F11.31. 7.13 F12 Group: Keypad and Display Parameter realized. If F12.00=0, this function does not work; if F12.00=Any other value, press this key to realize corresponding function.

According to setting of function code F00.02 (command source options), the command source has three control types, keypad control, terminal control and communication control, i.e., if terminal control is selected as command source, buttons STOP RESET of keypad will be disabled. However, in emergency, user often uses of keypad to stop inverter for the purpose of eliminating risks, which is the fastest way. However, during normal running of inverter, it is the most convenient way to stop inverter through keypad. Therefore, function code F12.01 is added and default setting is that STOP button is always enabled. ★ It’s not recommended to modify this function code.

If necessary, please pay enough attention. In order to avoid unnecessary risks caused by misoperation or non-personnel operation of keypad, keypad has the parameter locking function. If default setting of this function code is “unlocked”, you can set all function codes; after all function codes are debugged according to applications, user may lock parameters.  1: Reference Input, Unlocked 202 Function Code Name of Function Code Parameter Description Unit Default Property F12.00 M.K 0: No Function 1: Forward JOG 2: Reverse JOG 3: Forward/Reverse Switc 4: Rapid Stop 5: Coast to Stop 6:

Cursor Left Shift h 1 〇 M.K Function Name of Function Parameter Description U nit Default Property Code Code F12.01 STOP 0: Valid Only at Keypad Control 1: Valid at All Command Channels 1 〇 RUN STOP RESET Function Code Name of Function Code Parameter Description Unit Default Property F12.02 Parameter Locking 0: Unlocked 1: Reference Input, Unlocked 2: All Locked Except this Function Code 0 ●