EM600 High-Performance Vector Control Inverter User Manual Appendix V DeviceNet Expansion Card (EC-CM-D1) V.1 General Communication card EC-CM-D1 is defined as DeviceNet slave communication card and used to connect EM600 inverter to DeviceNet network. Main features: 1. Support connection mode “Group 2 only” of DeviceNet communication protocol, and support I/O polling data exchange. 2. I/O mapping supports up to 16-byte input and 16-byte output. 3. Support three communication rates via DeviceNet bus, respectively 125 kbps, 250 kbps and 500 kbps. 4. Support direct setting of node address and communication rate on inverter. 5. Automatically obtain power from inverter. 6.
Monitor inverter in real time based upon high-speed communication port of SINEE Modbus communication protocol. V.2 Installation Instructions Install DeviceNet card into expansion slot EC-B (make sure it is installed and buckled properly). Disassemble or install DeviceNet card only after inverter is powered off. Figure 4 Installation of DeviceNet Expansion Card Point DeviceNet expansion card at interface and location hole of expansion slot, and fix them with screws. 288