sinee — 4.5 Parameter Copy

EM600 High-Performance Vector Control Inverter User Manual displayed value is F00.03; press to back to F00.03. The following figures will be shown: to switch to F00.07 and press ENTER ESC Flashing bit Flashing bit 闪烁位 ENTER 闪烁位 Figure 4-7 Changing Function Parameters under Non-Factory Defaults Mode 4.3 Fault Monitoring When inverter is in fault state, press >> directly to switch among present fault type, fault output frequency, fault output current, fault output voltage, fault control mode and fault working time. 4.4 Operation Monitoring When the menu displayed is level 0 monitoring menu, press >> to switch sequence of 8 monitoring parameters of each function code as per F12.04 - F12.08.

If any bit of a function code is set as 1 and confirmed active, user may, through the button, display the value of corresponding monitoring parameter after returning to monitoring menu; otherwise, if the bit is set as 0, the value of corresponding monitoring parameter will not be displayed. 4.5 Parameter Copy Keypad can upload and download parameters, facilitating users for parameter setting in using inverters of the same function parameters. When setting function code F12.03 as 1 and pressing ENTER for confirmation, relevant parameters of inverter are uploaded to keypad with keypad displaying “UP” during uploading; after uploading, function code will change to 0 automatically.

Afterwards, keypad can be inserted to other inverters that need the same parameters; set function code F12.03 as 2 for downloading the parameters saved in keypad to inverter, with keypad displaying “DN” during downloading. After downloading, function code will change to 0 automatically. Special attentions are required for the following: 1. To download parameters from keypad, user must upload parameters at first. Those parameters in keypad without uploading are unknown; downloading such parameters may disorder parameters in inverter and as a result, inverter may break down.

Therefore, download parameters without parameter uploading would prompt “No DN”, which indicates that parameters are not downloaded successfully; press ESC to exit, and upload and then download these parameters again. 51