User Guide of EM730 Series Inverter 91 format 1: 1-8-E-1 (1 start bit + 8 data bits + 1 even parity check bit + 1 stop bit) 2: 1-8-O-1 (1 start bit + 8 data bits + 1 odd parity check bit + 1 stop bit) 3: 1-8-N-2 (1 start bit + 8 data bits + 2 stop bits) 4: 1-8-E-2 (1 start bit + 8 data bits + 1 even parity check bit + 2 stop bits) 5: 1-8-O-2 (1 start bit + 8 data bits + 1 odd parity check bit + 2 stop bits) F10.03 485 communicatio n timeout 0.0s-60.0s; 0.0: invalid (valid for the master-slave mode) s 0.0 ● F10.04 Modbus response delay 1 - 20 ms 2 ● F10.05 Options of master-slave communicatio n function 0: Invalid 1: valid 0 〇 F10.06 Master-slave options 0: slave 1:
host (Modbus protocol broadcast transmission) 0 〇 F10.07 Data sent by host 0: output frequency 1: set frequency 2: output torque 3: set torque 4: PID setting 5: output current 1 〇 F10.08 Proportional factor of slave reception 0.00-10.00 (multiple) 1.00 ● F10.09 Host sending interval 0.000-30.000 s 0.200 ● F10.10 Communicatio n protocol option 0: Modbus-RTU protocol 0 × F10.56 Options of 485 EEPROM writing 0-10: default operation (for commissioning) 11: writing not triggered (available after commissioning) 0 〇 F10.57 Enabling of SCI sending timeout resetting 0:invalid resetting 1: valid resetting 1 ● F10.58 Delay time of 110~10000 ms 150 ●