User Manual of EM730/EM730E Series Inverter 1. Motor parameter self-learning is valid only in the keyboard-controlled start/stop mode (F00.02=0): Set F01.34 to the corresponding value, and press the ENTER key to start motor parameter self-learning. After the parameter self-learning, F01.34 of the inverter will be automatically set to 0; 2. If there is an overcurrent or overvoltage protection during self-learning, extend the acceleration and deceleration time and try again. 3. The first group of motor parameters is taken as an example above. For the second group of motor parameters, refer to the above description.
for confirmation and then the RUN key 7.3 Function Parameter Group of Input Terminal of F02 Group The standard EM730/EM730E series inverter is equipped with five multi-function digital input terminals (X1 to X5) and two analog input terminals (AI1 and AI2, to be used with the corresponding function set to digital input, as detailed in the F02.31 description). The terminals X1 to X5, AI1 and AI2 are seven multi-function input terminals. The functions of the input terminals can be defined by setting the values of the function codes F02.00 to F02.14. For example, if you define F02.00=1, the function of the X1 terminal is “RUN”.
If the command source is set to terminal control (F00.02=1) and the X1 terminal input is valid, the “RUN” function of the inverter will be enabled. Specific options are described in Table 7-6.
If multiple terminals are set to the same function (except for #34 function terminal), the 152 Function Default Function code name Parameter description Unit Attribute code setting F02.00 Options of X1 digital input function See Table 7-6 Function List of Multi-function Digital Input Terminals 1 〇 F02.01 Options of X2 digital input function 2 〇 F02.02 Options of X3 digital input function 11 〇 F02.03 Options of X4 digital input function 12 〇 F02.04 Options of X5 digital input function 13 〇 F02.07 Options of AI1 digital input function 0 〇 F02.08 Options of AI2 digital input function 0 〇