Specimen examples Rook Rook 4.__Adding the visible edges (F5) it r= i 1. Creating a work piece (See page work piece (F1)) @ = 20mm, length = 65 mm, center hole 8.5, 5 Drawing aid Ci | op: 5. 5. Mirroring the work piece contour (F6) The work piece is enlarged across the whole of the screen surface by means of the hotkey 2. Drawing the work . *“ piece contour (See submenu point, line/hotkeys) 6.__ Storing the work piece contour (See ARCHIVE (F8)) Note Only the lower half of the work piece contour 9 ao must be drawn.
8 Contour points Note on inside turning X direction Since inside turning is carried out in overmounted form (without center punch Z direction 1 -4 2 -4 3 0 4 0 5 -16 6 -19 7 -44 8 -44 9 -50 support), feed (F) and advance should be as small as possible. F = approx. 20 mm/min Advance approx. 0,2 mm For inside turning of small diameters the inside cutting tool has to be set obliquely to avoid collisions (A). However, mind in any case that a clearance angle remains tool tip to guarantee a perfect cut. 107 behind the