Emco Compact 5 PC — Emco Compact 5 PC CNC Lathe Software Description & User Manual PDF

Menu points Draw Drawing a complete circle (360°) (F5) Unit: [mm] Position the cursor by means of the arrow keys on the centre point of the desired complete circle. Press F5, enter the radius of the circle and confirm it. Adding a fillet Unit: [mm] 1. 2. Both lines must contact at this point. The cursor must be positioned near to this bit. Example: - Example: Constructing a complete circleR = 15mm Screen message (F7 Radius = 5mm Screen message Entry Entry 5 [al [x] Radius for the corner? is the radius correct (ENTER Circle radius 10.000 (ENTER 15 [ci] = no change): = yes) Possibilities: ENTER = confirming the desired radius Any other key = interruption of this command "Adding the fillet”.

C3 WY > Drawing an arc with three points (F6) Determine the starting point and the end point. Position the cursor on the circumference of the desired arc (= third point). An arc is drawn through the starting, end point Fill two elements and cursor position, when the key F6 is pressed. Geometric (F8 elements (points, lines, circles or arcs) are filled tangentially by an arc. Note: Arcs are always drawn anti-clockwise. You can define the position of the arc by the Note: if you want to fill a circle or an arc, the prompt from the system for the type of filling appears. selection of the starting and end points. 5 E O There are two possibilities. E 5 O Filling 1:

in front of the circle V————, Me Example: 2. Starting point: End point: Cursor position: a ET s.yugint A Se ee X = 25mm, Z = 36mm X = 16mm, Z = 25mm X = 18mm, Z = 32mm ce, POPS C) The arc is drawn, when F6 is pressed. Filling 2: including the circle C 65