Menu points Program Follow contour cycle (F3) \f F3 - follow contour is pressed, the point nearest to the cursor is suggested as the starting point. lf a finishing offset was determined in the menu points roughing or back pocket, this is machined with the follow contour cycle. Possibilities Finishing = Dimension-accurate finishing Confirming the starting point Another of point is suggested as the starting point. the work piece contour 3. Determining the contour points (1, 2, 3, 4, 5) After the starting point has been determined, the contour points of the work piece contour drawn must be determined. These contour points are suggested to you. 6 x Procedure 1.
‘I Position the tool near to the starting point (S) in the rapid (F1) or with the feed speed (F2) and press F3. Possibilities [=] Note Confirming the contour point Displaying the next contour point in the opposite direction Omitting the suggested contour point Ending the contour point determination lf a cycle was previously machined, the following message appears on the screen: New or ast contour (ENTER = last): Note Only the Re-machine the last defined contour. Define the new contour. can be finished with the selected tool, are confirmed points of the machining, which as contour points. E.g., the holes (point 3, 4, 7, 8) may not be confirmed. 2.
Determining the starting The starting point must always be of the the point foliow outermost contour point on cycle the machined contour in the Z direction. 4. Entering the technological data The input of the finishing offset and feed speed is carried out exactly as described in the chapter “roughing cycle”. Starting point 79