US Army Materiel Command AMCP 706-197 — AMCP 706-197 Reliability Prediction Handbook — US Army Engineering Design Guide PDF

Downloaded from https://www.everyspec.com AMCP 706-197 ments are polarized. Polarized elements allow ure when the elements are susceptible to current to flow in one direction only. both. The failure conditions, reliability equa- For identical nonpolarized elements tion, approximate probability of failure, and which allow current to flow in either direc- impedance variation due to redundancy are tion (Ref. 2) presented.

R =(I - q,, - 9)[q4 - 2q 2 + (1 -q2)2 10-3 DECISION-WITHOUT-SWITCHING I o REDUNDANCY + q_, ((1 - %) - 11 - (1-,) ]} + q10-3.1 MAJORITY LOGIC REDUNDANCY For identical polarized elements which allow Majority logic is a form of decision redun- current to flow in one direction only, dancy for which the correct output is as- sumed to be the one found in a majority of R =(1- q,, - q)[2q 3 - 3q 2 + (1- )] the channels. The concept of majority logic + q,, (1 - q) _ -1- (1- ,) was first proposed by von Neumann and has q,,) 2 1 2 since been enlarged upon by many authors. + q.

{(1 - q.) 2 - [1- (1 - q) 2 1 2 } Von Neumann's original concept required extremely high redundancy to achieve high (10-17) reliabilities, but later techniques give high reli- Although conditional reliability increases ability with a rather low degree of redun- as a result of using a Quad, several important dancy. Typical structures are shown in Figs. design factors must be considered, namely: 1.0-8 and 10-9. 1. Using transistors in a Quad configura- The probability of success for the major- tion subjects them to more vigorous and ity group is, from Eq. 8-17, demanding parameter requirements. 2n + 2. The redundant configuration can drive p = p,.

E (2 i+ I) pi q 2 + 'i (10-18) but one fourth the load of the nonredundant i, it circuit. where a 3. The Quadding approach is inherently !p = probability that a circuit is oper- a slower one, increasing signal propagation ating properly time by at least 2:1. q = (1 - p) = probability that the cir- 4. The redundant design will dissipate up cuit has failed to, and possibly more than, four times the p, = probability of success of Majority power of a single transistor, if maximum Vote Taker MVT speed is desired. 2n + 1 = number of units. 5. The Quadding layout usually will demand a greater supply voltage and, there- fore.

cause the minimum power ratio to be .- about 2:1, redundant to nonredundant. 6. Failure of any unit of a Quad can in- crease semiconductor heat dissipation per unit U Input Output up to four times. A direct consequence of this V 0 or 1 0 or is requiring the lowering of ambient operating - temperature to keep semiconductor junction temperatures below the danger point. 2 10-2.5 SUMMARY TABLE Col.putinq Blocks MN1oritv Logic. E Ul Weights Table 10-1 summarizes the important MVT Mboity Vote Taker characteristics of comp~onent redundancy for charaerstics fombin one f redundancn fair- FIGURE 10-8. Basic Majority Vote Redundant different combinations of short to open fail- Circuit' 10-7